Pioneer PDP-501MX - Manual (Page 90)

90
Integrator Mode
Screen 1
]
MENU – –
WHITE BALANCE
3SCREEN
ADDITIONAL SET UP
TOTAL INITIALIZE
PICTURE
SCREEN – –
V. POSI. 128
CLK FRQ 128
CLK PHS 8
3H. POSI. 128
INITIALIZE
EXIT
Screen 2
]
Screen 3
]
SCREEN
H. POSITION 128
3) Adjusting the SCREEN Parameters
SCREEN parameters include H.POSI., V.POSI., CLK FRQ, and CLK PHS.
1 Before entering the Integrator mode, switch the unit to the
specific input (one of INPUTs 2-4) in which you intend to make
adjustments. (Refer to “5.4.1 About Integrator Mode.”)
The ID number of the set of items will be indicated in the
upper right corner of the screen, where “– –” is displayed in
the illustration.
Select SCREEN.
2 Select the desired adjustment item.
Selecting INITIALIZE on screen 2 resets all SCREEN
parameters to their default values. (Refer to “5.4.3,” paragraph
9).)
Select EXIT in screen 2 to return to screen 1.
3 Make the necessary adjustments.
NOTE: CLK PHS can only be adjusted when INPUT 3/4 is
set to PC.
NOTE: V.POSI. can’t be adjusted when the screen size is
set to ZOOM or CINEMA WIDE.
(V.POSI is also adjustable in ZOOM mode if a
1280 x1024 signal is input from a PC at 60 Hz.)
Adjustments can be made using the “
2“ and “3” buttons
on the remote(or the “ ∞“ and “5” buttons for V.POSI.), or
the “–” and “+” buttons on the operating panel of the main
unit.
Values set and adjusted for H.POSI., V.POSI., and CLK FRQ serve as median values when adjustments are made
in Menu mode.
CLK PHS has the same data as the CLK PHS accessible in Menu mode.
Press the SET button to return to screen 2.
<Adjustable Range> 0 to 255 for H.POSI. and V.POSI.
64 to 192 (median: 128) for CLK FRQ
0 to 16 for CLK PHS
<Adjusting Order> For the sake of efficiency, make adjustments in the following order:
V.POSI.
= H.POSI. = CLK FRQ = H.POSI. = CLK PHS