NEC LT240 - Manual (Page 28)

E-28
Making Connections
INSTALLATION AND CONNECTIONS
VCR, DVD Player or
LaserDisc Player
Macintosh
(Desktop type or notebook type)
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player
(with component output)
Document Camera
To video, S-video, and au-
dio inputs on the projector.
Optional 15-pin-to-RCA
(female)
ן
3 cable
(ADP-CV1)
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on the pro-
jector. It is recommended that you use a com-
mercially available distribution amplifier if con-
necting a signal cable longer than the sup-
plied cable.
Monitor
NOTE: When using with a notebook PC, be sure to connect between the projector
and the notebook PC before turning on the power to the notebook PC. In most
cases signal cannot be output from RGB output unless the notebook PC is turned
on after connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of
the computer's screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 90 sec-
onds and then press the POWER button again to resume.
Wiring Diagram