NEC LT240 - Manual (Page 99)

E-99
USING ON-SCREEN MENU
Ͼ
Menu Descriptions & Functions
Enabling Auto Start [Auto Start]:
Turns the projector on automatically when the power cable is in-
serted into an active power outlet and the main power switch is
turned on. This eliminates the need to always use the "Power" but-
ton on the remote control or projector cabinet.
Enabling Power Management [Power Management]:
When this option is on and there is no input for five minutes or more,
the projector will automatically turn itself off.
Enabling Power Off Confirmation [Power Off Confirmation]:
This option determines whether a confirmation dialog for turning off
the projector will appear or not.
NOTE: When the confirmation message is displayed, you must be in the
Projector mode to operate your projector using the remote control. If not,
press the PJ button on the remote control to change your projector to the
Projector mode. The button lights to indicate that you are in the Projector
mode.
Enabling Horizontal and Vertical Keystone Correction Save:
[3D Reform Save]
This option enables you to save your current 3D Reform settings.
Saving your change once affects all sources. The changes are saved
when you turn off the projector.
Enabling Fan High Speed Mode [Fan High Speed Mode]:
This option allows you to select two modes for fan speed:high-speed
mode and normal speed mode.
When you wish to cool down the temperature inside the projector
quickly, check this box.
NOTE: Enable Fan High-Speed mode if you continue to use the projector
for consecutive days.