NEC WT600 - Manual (Page 17)

2-1
Your projector is simple to set up and use.
But before you get started you must first:
1. Set up a screen and the projector.
NOTE: Using a warped screen can cause an image to appear distorted.
2. Connect your computer or video equipment to the projector. See page 2-3 to 2-7.
3. Connect the supplied power cable. See page 2-7.
NOTE: Ensure that the power cable and any other cables are disconnected before moving the projector. When moving the projector or when it is
not in use, close the mirror cover on the top cabinet.
This section describes how to set up your projector and how to connect video and audio sources.
2. Installation and Connections
When installing the projector for the first time, read the WT600 Setup Guide carefully.