NEC WT600 - Manual (Page 20)

2-4
PC CARD
AUDIO IN
R L /MONO
VIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUT
DVI-I RGB AUDIO IN USB AUDIO OUT PC CONTROL REMOTE IN
RGB IN
1. Turn off the power to the projector and your video equipment.
2. Use the NEC ADP-SC1 SCART adapter and a commercially available SCART cable to connect the RGB input of your projector
and a SCART output (RGB) of your video equipment.
3. Turn on the power to the projector and your video equipment.
4. Use the RGB button on the remote control to select the RGB input.
5. Press the MENU button on the remote control to display the menu.
6. From the Advanced menu, select [Projector Options] → [Setup] → [Page 3] → [Signal Select RGB] → [Scart].
SCART is a standard European audio-visual connector for TVs, VCRs and DVD players. It is also referred to as Euro-connector.
NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Europe. Contact your NEC dealer in Europe for more information.
Using two RGB inputs simultaneously
If you need to use two RGB inputs simultaneously, connect the supplied DVI-A to VGA cable as shown below.
Video equipment such as DVD player
Projector
ADP-SC1 Commercially available SCART cable
Female
To RGB IN
To connect SCART output (RGB)
Before connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are required for this
connection.
NOTE: Audio signal is not available for this connection.
2. Installation and Connections
PC CARD
AUDIO IN
R L /MONO
VIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUT
DVI-I RGB AUDIO IN USB AUDIO OUT PC CONTROL REMOTE IN
DVI-I IN RGB IN
RGB signal cable
(supplied)
IBM PC or Compatibles (Desktop
type) or Macintosh (Desktop type)
DVI-A to VGA cable
(supplied)
IBM PC or Compatibles (Notebook type)
or Macintosh (Notebook type)