NEC WT600 - Manual (Page 21)

2-5
PC CARD
AUDIO IN
R L /MONO
VIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUT
DVI-I RGB AUDIO IN USB AUDIO OUT PC CONTROL REMOTE IN
RGB OUT
Connecting an External Monitor
NOTE:
• The RGB OUT connector can output RGB signal even during idle
mode (See page 6-17 for enabling the Idle mode). When the pro-
jector goes into idle mode, the image on an external monitor dis-
appears for a moment. Note that the RGB OUT connector will not
output RGB signal during Standby mode.
• When the projector is in the Idle mode, the image may not be
correctly displayed while the cooling fans are running immedi-
ately after turning on or off the power. Note that the RGB OUT
connector will not output RGB signal during Standby mode.
• Daisy chain connection is not possible.
You can connect a separate, external monitor to your projector
to simultaneously view on a monitor the RGB analog image you're
projecting. To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the RGB OUT
(Mini D-Sub 15 pin) connector on your projector.
3. Turn on the projector, monitor and the computer.
RGB signal cable
(supplied)
RGB signal cable (commercially available
or supplied with an external monitor)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you use
a commercially available distribution
amplifier if connecting a signal cable
longer than the supplied one.
2. Installation and Connections