NEC WT600 - Manual (Page 22)

2-6
PC CARD
AUDIO IN
R L /MONO
VIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUT
DVI-I RGB AUDIO IN USB AUDIO OUT PC CONTROL REMOTE IN
AUDIO IN
L R
AUDIO OUT
L R
Component
Y Cb Cr
AUDIO IN RGB
RGB IN
Connecting Your DVD Player
You can connect your projector to a DVD player with component
output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output,
use a commercially available component video cable (RCAX3)
and the optional 15-pin-to-RCA (female)
ן 3 cable to connect
your DVD player to the RGB IN connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output,
use common RCA cables (not provided) to connect a com-
posite VIDEO output of the DVD player to the Video Input of
the projector.
3. Turn on the projector and DVD player.
NOTE: Refer to your DVD player's owner's manual for more informa-
tion about your DVD player's video output requirements.
Audio cable (not supplied)
Audio Equipment
DVD player
Component video RCA ן 3 cable
(not supplied)
Optional 15-pin-to-RCA
(female)
ן 3 cable (ADP-CV1)
2. Installation and Connections