NEC WT600 - Manual (Page 28)

3-5
3. Projecting an Image (Basic Operation)
Setting the function switch
There are two switches on the bottom of the battery case: an
applicable projector selector switch (1) and laser enable/disable
switch (2). On this model, an applicable projector selector switch
(1) is not used. Decide whether to enable or disable laser, then
set this switch as necessary using the tip of a thin ball-point pen.
ON OFF
Switch (2)
On: Enabled (the laser lights when the LASER button is
pressed) [Factory default]
Off: Disabled (the laser does not light even when the LA-
SER button is pressed)
Disable the laser when using in an environment in which the
unit is accessible to children.
3-7. Turning off the Projector
ASPECT
OFF
VIDEO
AUTO ADJ.
RGB VIEWER
LASER
ON
3D REFORM
HELP POINTER
VOLUME MAGNIFY
ZOOM
PIC-MUTE
SLIDE
FOLDER
SLIDE
LIST
POWER
FREEZE
FOCUS
To turn off the projector:
First press the POWER (ON/STAND BY)
button on the projector cabinet or the
POWER OFF button on the remote con-
trol for a minimum of two seconds. The
power indicator will glow orange. After the
projector turns off, the cooling fans keep
operating for 90 seconds (Cooling-off time).
Second, turn off the Main Power switch.
The power indicator will go out. Lastly un-
plug the power cable.
CAUTION
Do not unplug the power cable from the wall
outlet or do not turn off the main power un-
der any one of the following circumstances.
Doing so can cause damage to the projec-
tor:
• While the Hour Glass icon appears.
• While the message "Please wait a mo-
ment." appears. This message will be dis-
played after the projector is turned off.
• While the cooling fans are running. (The
cooling fans continue to work for 90 sec-
onds after the projector is turned off).
• While accessing a PC card. (The PC Card
Access indicator lights.)