Nortel Networks P0857846 - Manual (Page 140)

Using System features / 127
P0857846 Issue 02 Norstar-PLUS Modular ICS 2.0 System Coordinator Guide
Using special telephones
Direct-dial
You can reach the direct-dial telephone by dialing a single digit. The
direct-dial telephone is usually in a central location, such as a
attendant's desk. You can have up to five direct-dial telephones for
your Norstar system. It is usually the prime telephone or the central
answering position (CAP).
The direct-dial telephone can send up to 30 messages and can
invoke Services to activate the extra-dial telephone.
You cannot forward calls to a direct-dial telephone that is outside
your Norstar system. See “Making changes to Call Forward No
Answer” on page 22.
Changing the direct-dial telephone assignments
Your installer or customer service representative sets up the direct-
dial telephone.
You can change which direct-dial telephone a telephone is assigned
to, or assign it no direct-dial telephone.
You will need the programming template found at the front of this
guide. See Getting Started for more information.
1. Press ƒ••¤flfl‹›› .
2. Press ¤‹fl›fl (the default System Coordinator
password).
3. Press ≠ at Terminals&Sets .
4. Enter the internal number of the telephone you wish to program
and press
≠ . The display reads Capabilities .
5. Press ≠ .
6. Press ‘ until the display reads D-Dial .
7. Press CHANGE to select Set1, Set2, Set3, Set4, Set5 or None .