Nortel Networks P0857846 - Manual (Page 88)

Forwarding your calls / 75
P0857846 Issue 02 Norstar-PLUS Modular ICS 2.0 System Coordinator Guide
If you use ALL to redirect all your lines, it is important that you wait
until all the lines on your telephone light up before pressing
˙ or OK. If you press ˙ or OK before all the lines light
up, those lines not lit will not be redirected.
Canceling Line Redirection
• Press ƒ£°› .
• Select the lines you no longer want to be redirected.
Allowing a telephone to redirect calls
You can turn a telephone’s ability to redirect calls on and off.
You will need the programming template found at the front of this
guide. See Getting Started for more information.
1. Press ƒ••¤flfl‹›› .
2. Press ¤‹fl›fl (the default System Coordinator
password).
3. Press ≠ and enter the internal number of the telephone
you wish to program.
4. Press ≠ twice.
5. Press “ four times. The display shows Allow
redirect: .
Tip - The line chosen for redirecting calls on other
lines can still be used normally when it is not busy
on a redirected call. To avoid redirection failing
because the chosen line is in use, choose a line
pool with several lines in it.
The system does not check that the number you
give for line redirection is a valid one. If you redirect
to an invalid number, redirection will fail. Using an
autodial button to enter the redirection number
helps avoid this possibility. An autodial button used
for line redirection must be programmed to use a
specific line.
ƒ£°›