NEC GT2000 - Manual (Page 17)

E-17
INSTALLATION 2
This section describes how to set up your MultiSync GT2000/
GT2000R LCD projector and how to connect video and audio
sources.
Setting Up Your MultiSync GT2000/
GT2000R LCD Projector
Your MultiSync GT2000/GT2000R LCD Projector is simple to
set up and use. But before you get started, you must first:
1. Determine the image size
2. Set up a screen or select a non-glossy white wall onto which
you can project your image.
Carrying The LCD Projector Ensure that the power cord and
any other cables connecting to video sources are disconnected
before moving the projector. When moving the projector or
when it is not in use, cover the lens with the lens cap.
Selecting A Location The further your LCD projector is from
the screen or wall, the larger the image. The minimum size the
image can be is approximately 0.5 m (20") measured diago-
nally when the projector is roughly 1.0 m from the wall or
screen. The largest the image can be is 7.6 m (300") when the
projector is about 12.0 m from the wall or screen.
Width
Height
Screen size
(diagonal)
Projection distance
Attaching the lens cap to the lens hood with the supplied
string and rivet. (GT2000 only)
Lens cap
Rivet
String