NEC GT2000 - Manual (Page 40)

E-40
[Keystone distortion] [No distortion]
Keystone Save
On
Off
Settings Menu
Language
Background
Auto Start
Auto Save
Onscreen Mute
Swithcer Control
Ext. Control
Projector ID
Sync Termination
Projection
Keystone
Keystone Save
– + –10
Normalize?
Keystone
Yes
No
Selecting Correction and Storage of Keystone
Distortion [Keystone]
Keystone distortion arises when the angles are off between the
projector and screen in the vertical orientation at the time of setting
up the projector. The keystone function is used in this distortion
adjustment.
When the setting is permanent, setting the keystone save function
to On will enable projection using this adjustment value from the
next occasion.
• Adjusting Keystone Adjustment [Keystone]
1. Select [Settings Menu]
→
[Keystone] from the main menu.
The adjustment bar will be displayed.
2. Press the cursor
ᮤ (–) / ᮣ (+) button and adjust so that the left and
right sides are parallel.
NOTE: This function will not work when the input signal is not
present. If this is the case, apply an signal and make the adjusment on
it.
• Setting Keystone Save [Keystone Save]
1. Select [Settings Menu]
→
[Keystone Save] from the main menu.
2. Press the cursor ▲/▼ button and select On/Off, then press the
ENTER button to set.
On .... Enables the keystone correction value at starting
time.
Off .... Sets the keystone correction value to the default
value at starting time.
To return to the default value, press the NORMAL button of the
remote control.
Press the cursor ▲/▼ button and select [Yes], then press the
ENTER button to return to the default value.