Runco PL-61CX - Manual (Page 13)

3
Rear View / Terminal Board
SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM RIGHT LEFT AC IN
SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM
RIGHT LEFT AC IN
A B
VIDEO (IN
/OUT
)
VIDEO
1
VIDEO
2
VIDEO
3
AUDIO
1
DVD
1 / HD
1
R
(MONO
) L
Y
Cb
/Pb
Cr
/P
r
RGB
2 / DVD
2
/ HD
2
RGB
1
R/
VD
G /
B /
HD
(IN
/O
UT
)
D V I (
Digital RGB
)
AUDIO
2 R
(M O N O ) L
AUDIO
3 R
(MONO
) L
Cr/Pr
Y
C b /P
b
RGB
3
External Control
IN
OU
T
REMOTE
D
C
E
F
G
H
I
J
K
A AC IN
Connect the included power cord here.
B Connect speakers (optional) here. Maintain the
correct polarity. Please refer to your speaker’s
owner’s manual.
C VIDEO 1,2,3 (BNC, RCA, S-Video)
Connect VCR’s, DVD’s or VIdeo Cameras, etc
here. VIDEO1 can be used for INPUT or OUTPUT.
D AUDIO1, AUDIO2, AUDIO3
These are audio input terminals. The input is selectable.
Set which video image to distribute them from the audio
menu screen.
E DVD1 / HD1
Connect DVD’s, High Definition or Laser Discs, etc here.
F RGB2 / DVD2 / HD2
RGB2: Connect an analog RGB signal and the
synchronization signal.
DVD2 / HD2: Connect DVD’s, High Definition sources,
Laser Discs, etc. here. This input can be set for use with an
RGB or Component source.
G RGB1 (mini D-Sub 15pin)
Connect an analog RGB signal from a computer, etc. here.
This input can be used for Input or Output.
H RGB3 (DVI 24pin)
Connect a digital signal (TMDS) from a source with a DVI
output.
I EXTERNAL CONTROL
This terminal is used when operating and controlling the
monitor externally by RS-232.
J REMOTE IN
Connect the remote cable* to the remote control’s remote
jack to obtain wired remote control).
K REMOTE OUT
Connect the remote cable* to the REMOTE IN jack of the
other display monitor to obtain wired remote control.
* The 1/8 Stereo Mini cable must be purchased separately.