Runco PL-61CX - Manual (Page 72)

PFP™ Controller Troubleshooting
The following is a basic troubleshooting guide that can assist you in resolving typical problems may result
in normal operation. If you have encountered problems that are not listed in this guide, please contact your
Runco dealer for assistance.
The Plasma does not turn on
after initial installation. The
Power LED on the front of
the Controller stays
yellow after the power button
is pressed.
The Plasma and Controller
are both on, but there is no
video image on-screen.
· The RJ-11 (ComLink) cable
is not connected between the
Controller and Plasma, or is
made improperly.
· The Plasma is not plugged
in, or its AC outlet is not
active. Look at its power LED
on the front panel.
· The Controller is on the
wrong source.
· The Controller is on the
correct source, but the source
itself is off.
· Use a standard RJ-11
phone-type cord. Ensure it
is firmly plugged into both
the Controller and the
Plasma.
· Ensure there is good con-
tinuity in the RJ-11 cable.
· Verify that the AC outlet is
active, or that the Plasma
is plugged in by turning on
the main power switch
located at the rear of the
unit.
· Press MENU on the
Plasma's remote, and look
to see which source is
active (the arrow will be
pointing to the active
source). Select the correct
source as appropriate.
· Turn on the source. It is
recommended that all
sources be turned on first
before the PL-61cx.
PROBLEM POSSIBLE CAUSE SOLUTION
6 2