Runco PL-61CX - Manual (Page 27)

Menu Description and Navigation
INPUT SELECT
Standard Video:
Composite
S-Video
Component
High Definition:
Component
RGB
ASPECT RATIO SELECT
INSTALLER ADJUST*
Menu Tree
Anamorphic
Standard 4:3
Letterbox
Virtual Wide
Tint
Color
Brightness
Contrast
Sharpness
Luma Enhance*
Chroma Enhance*
Color Balance*
The menu tree above is an overall glance at the menu system in the PL-61cx.
The description of the menus and their functions are below.
The main menu includes three main sections: INPUT SELECT (Composite, S-video, Component,
HD Component, HD RGB), ASPECT RATIO SELECT and INSTALLER ADJUST .
These menus are described in detail below:
INPUT SELECT is done by highlighting the desired source with the up or down arrows and pressing
ENTER. Sources may also be selected by pressing the left or right arrows on the front panel or remote,
or by one of the direct access buttons on the remote. High Definition or progressive DVD
signals are input to the HDTV port.
ASPECT RATIO SELECT is done by highlighting 'Aspect Ratio' on the main menu and pressing
enter. The Aspect Ratio menu will then appear; and either ANAMORPHIC, STANDARD 4:3,
LETTERBOX or VIRTUAL WIDE may be selected. Aspect ratios may also be selected by pressing either
the up or down arrow buttons, or by one of the direct access buttons on the remote.
INSTALLER ADJUST is used for adjustments usually made during the initial installation. This
includes Image Shift, Blanking, Side Bar Level and IR Code Select.
Main Menu
Side Bar Level
Invert
Off
Output Shift
Input Shift
Blanking
IR Code Select
Red Gain
Green Gain
Blue Gain
Red Offset
Green Offset
Blue Offset
>
Brightness
Contrast
* Menus are only available during “Installer Mode”.
17