Runco PL-61CX - Manual (Page 24)

Rear Panel
12V TRIGGER
12V FUSE
RGB OUTPUT VIDEO INPUTS
RS-232 IN
MADE IN USA
AC 120V 60Hz, 15W
MASK SCREEN
HDTV COMPOSITE V H B G R Y Pr Pb S-VIDEO
MADE IN USA
RUNCO INTERNATIONAL
UNION CITY, CA
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
6 7 8 9 10 4 2 3
1 5
11 12 13
COMLINK OUT
14
1. 12v FUSE
This fuse protects the 12v outputs from the MASK and SCREEN jacks.
(Screen Fuse: 5mm x 25mm, AGC, 0.5A, 250V, Fast Blow)
2. MASK
This is a 12V output that can be used to trigger curtains, lifts, etc. (1/4A maximum load).
3. SCREEN
This is a 12V output that can be used to trigger curatins, lifts, etc. (1/4A maximum load).
4. RS-232 IN
This is for systems using serial (RS-232) to control the PFP Controller.
5. COMLINK OUT
The output of this jack must be connected to the ComLink input of the PL-61cx Plasma monitor.
If this is not connected, neither the Controller or the Plasma can operate.
6. RGB OUTPUT
This is the RGB output of the PFP Controller. Connect the RGB output of the Controller to the PL-61cx’s RGB BNC
port.
7. HDTV/PROGRESSIVE DVD
This is the input for HDTV or progressive DVD sources.
If the signal is RGB, select ‘RGB HD’; if it is Component, select ‘Component HD’.
8. COMPONENT INPUT
This is the input for Component Video from sources such as DVD players.
Note: The component output from a DTV decoder or a progressive-scan DVD cannot be used with this port;
it must be used with the HDTV port.
9. S-VIDEO INPUT
This is the input for S-Video from sources such as Satellite receivers, S-VHS VCR’s and DVD players.
10. COMPOSITE VIDEO INPUT
This is the input for Composite Video from sources such as laser disc players, VCRs and other misc. sources.
11. POWER INPUT
Plug in Main Power here.
12. 115 VAC FUSE
This is the main AC Input fuse (.5A/250V).
13. MAIN POWER SWITCH
Disconnects or applies main power to the Controller.