Runco PL-61CX - Manual (Page 34)

System Reset
In the event that your PL-61cx appears to have a software problem, or adjustments have been made so far out of
range that the image is no longer on-screen or discernable, you can reset the processor back to factory values. This
sets ALL settings back to factory values, so any adjustments made previously will be lost.
To reset your PL-61cx, follow this procedure:
· Turn off the MAIN POWER switch on the back of the processor
· Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back on.Continue holding the
down arrow button until the LED on the front panel blinks, then release the down arrow button.
Once this is done, your processor has been completely reset to factory values. After resetting the unit, Composite video
will be the active source.
SYSTEM RESET is not on any of the menus; it must be performed using the instructions above.
Blanking
The BLANKING function allows you to 'cut off' part of the image to fit the screen properly, or to eliminate anomalies on
the extreme outsides (usually the top) of the image. This can be done to the top, bottom, left or right sides individual-
ly.
To adjust BLANKING, highlight the desired area you wish to blank (top, bottom, left or right), and use the left and right
arrows to make the adjustment.
Blanking
Top 131
Bottom 707
Left 241
Right 1292
24