Runco PL-61CX - Manual (Page 15)

Use of Installation Remote Control
The Installation remote has been included with the PL-61cx in order to allow the adjustment of size and position for HDTV signals,
or any other high-resolution signal sent into the “HDTV/Computer” port on the Controller.
Do not use this remote to make color balance adjustments or any other image quality adjustments to the plasma itself. All image
quality adjustments are stored in the PFP Controller, NOT in the plasma. Any adjustments made to the plasma will not be stored and
will be lost when the plasma is turned off.
To adjust position or size for high-definition
signals, perform the following:
1. Press PROCEED.
2. Press the DOWN ARROW twice so “SCREEN”
is highlighted and press PROCEED.
3. Select either V or H POSITION, V HEIGHT or
H WIDTH as desired, and press PROCEED.
4. Using the arrow buttons, adjust the position or
size as necessary.
5. When done, press EXIT several times until the
menu disappears.
5