Runco PL-61CX - Manual (Page 73)

The image appears too
bright, and there is a loss
of definition in the bright-
est areas of the image.
The image appears too
'washed out', or the dark-
est areas of the image
appear too bright.
The colors of the image
appear abnormal
The Plasma will not turn
on, and the power LED on
the front of the Controller
is blinking red or green.
· Contrast is set too high.
· The DVD player is set for a
high-level output.
· The video signal has not
been terminated properly
somewhere in the system.
· Brightness is set too high.
· The DVD player may be set
for too high of a brightness
level.
· The Red, Green and/or
Blue outputs of the Controller
or inputs to the Plasma are
reversed.
· The Pr and Pb inputs on the
Component input on the
Controller are reversed
· The Controller may have
'locked-up'.
· Turn down the CONTRAST
level on the Controller. Mid-
range is -10; it is recom-
mended to keep it below 0 to
prevent this problem.
· Set the DVD player for a
nominal output (no boost or
gain).
· Ensure all video signals are
terminated in 75 Ohms.
· Turn down the BRIGHT-
NESS level on the Controller.
If possible, use a PLUGE
pattern to set the brightness
level properly.
· Set the DVD player for a
nominal output (no boost or
gain).
· Check the cable connec-
tions on the back of the
Controller or on the Plasma.
· Unplug the Controller for 2
minutes; plug it back in and
re-try.
· Perform a system reset on
the Controller and then re-try.
6 3