Runco PL-61CX User Manual
Page 71
61
* 1 Overheat Protector
If the monitor becomes too hot, the overheat protector will be activated and the monitor will be turned off. If this happens, turn off the power to
the monitor and unplug the power cord. If the room where the monitor is installed is particularly hot, move the monitor to a cooler location and
wait for the monitor to cool for 60 minutes. If the problem persists, contact your Runco Authorized Dealer.
* 2 In the following case, power off the monitor immediately and contact your Runco Authorized Dealer or Runco Authorized Service Center. The
monitor turns off 5 seconds after powering on and then the POWER/STANDBY indicator blinks. It indicates that the power supply circuit, plasma
display panel or temperature sensor have been damaged.