Runco PL-61CX - Manual (Page 17)

7
Using the wired remote control mode
Connect the remote cable* to the remote control’s remote
jack and the “REMOTE IN” terminal on the monitor. When
the cable is connected, the mode automatically switches to
wired remote control. When the wired remote control
is used, the remote control can be operated even if no
batteries are loaded.
Operating Range
* Use the remote control within a distance of about 23 ft.
(7m) from the front of the monitor’s remote control sensor
and at horizontal an vertical angles of up to approximately
30 o.
* The remote control operation may not function if the
monitor’s remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote control.
Handling the remote control
• Do not drop or mishandle the remote control.
• Do not get the remote control wet. If the remote control
gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote control for a long period,
remove the batteries.
• Do not use new and old batteries together, or use
different types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
• When using the remote control in the wireless condition,
be sure to unplug the remote cable from the REMOTE
IN terminal on the monitor.
External Contro
l
IN
OUT
REMOTE
Approx.
23 ft (7m)
*The 1/8 Stereo Mini cable must be purchased separeately.