Runco PL-61CX - Manual (Page 68)

COMMAND PARAMETER (min/max) Value stored? DESCRIPTION
ON NA NA Turns Controller on
OFF NA NA Turns Controller off
COMPOSITE NA YES Selects the Composite
Video input
SVIDEO NA YES Selects the S-Video Input
COMPONENT NA YES Selects the Component
Video input
HDCOMPONENT NA YES Selects the HDTV port for
Component signals
HDRGB NA YES Selects the RGB HD mode,
which switches the Plasma to
the RGB2 (BNC) input
ANAMORPHIC NA YES Selects the anamorphic
aspect ratio
STANDARD NA YES Selects the standard (4:3)
aspect ratio
LETTERBOX NA YES Selects the letterbox aspect ratio
VIRTWIDE NA YES Selects the Virtual Wide aspect
ratio
TINT -127/127 NO Sets a value for tint
COLOR -127/127 NO Sets a value for color
AGCCOLOR 0/1 NO 0=Disable Color AGC
1=Enable Color AGC
BRIGHTNESS -32/32 NO Sets a value for brightness
CONTRAST -52/20 NO Sets a value for contrast
AGCCONTRAST 0/1 NO 0=Disable Contrast AGC
1=Enable Contrast AGC
SHARPNESS 0/255 NO Sets a value for sharpness
CHROMAHIGH 0/127 NO Sets a value for high-frequency
chroma edge enhancement
CHROMALOW 0/127 NO Sets a value for low-frequency
chroma edge enhancement
LUMAHIGH 0/127 NO Sets a value for high-frequency
luminance edge enhancement
LUMALOW 0/127 NO Sets a value for low-frequency
luminance edge enhancement
RGAIN -40/30 NO Adjusts the amount of RED in
the white areas of the image
GGAIN -40/30 NO Adjusts the amount of GREEN in
the white areas of the image
BGAIN -40/30 NO Adjusts the amount of BLUE in
the white areas of the image
ROFFSET -40/30 NO Adjusts the amount of RED in
the dark areas of the image
GOFFSET -40/30 NO Adjusts the amount of GREEN in
the dark areas of the image
BOFFSET -40/30 NO Adjusts the amount of BLUE in
the dark areas of the image
PFP™ Controller RS-232 Commands
5 8