Roland V-Bass VB-99 - Manual (Page 30)

30
Chapter 2 Creating Sounds
1. Press [NAME/KEY/BPM].
2. Press [F2] (KEY).
3. Set the song’s key with [F1] (SELECT) or the
F1 knob.
* The COSM bass PITCH SHIFT, HARMO, and BEND settings and
the HARMONIST effect operate according to the key you set here.
4. If you want to save the edited settings,
perform the Write procedure (p. 34).
* If you do not want to save, press [EXIT] to return to the Play screen.
It is possible to combine the sound of the COSM basses and the
normal bass pickups at the same time.
1. Press [COSM BASS].
2. Set the COSM BASS SW to ON with [F1] or
with the F1 knob.
The sounds from the normal pickup and COSM bass are
not played when COSM BASS SW is set to OFF.
3. Press PAGE [ ] several times to move to the
screen for setting the volume balance.
4. Use the F1 and F2 knobs to set the balance
between the COSM bass sound and the
normal pickup sound.
F1 Knob
Adjusts the COSM bass’s volume level. When POLY FX is set
to ON, it adjusts the volume level of the signal after it has
passed through POLY FX.
F2 Knob
This adjusts the volume of the normal pickup.
When the COSM bass is connected in CHAIN at a point other
than the beginning of the effects chain, you can adjust the
volume of the sounds that have passed though effects from
the beginning of the chain up to the point where the bass is
connected.
5. If you want to save the edited settings,
perform the Write procedure (p. 34).
* If you do not want to save, press [EXIT] to return to the Play screen.
Setting the Key Mixing the Normal Pickup
Sound with the GK Input
Setting the Volume Balance
VB-99_e.book 30 ページ ２００８年８月１８日 月曜日 午後１時１０分