Roland V-Bass VB-99 - Manual (Page 156)

156
Chapter 8 Parameter Guide SYSTEM
CATEGORY NAME
D BEAM CALIB
(D BEAM Calibration)
PATCH EXTENT
FACTORY RESET
Parameter/
Range
Explanation
CATEGORY NAME
This sets the Category name.
INSERT Insert a space at the cursor location.
DELETE Delete a character. The characters that fol-
low get shifted to the left.
SPACE Input a space at the cursor location.
A0! Switch between uppercase letters, numbers,
and characters.
A<=>a Switch between uppercase letters and low-
ercase letters.
CATGRY Select the user category you want to name.
Parameter/
Range
Explanation
D BEAM DISAB (D BEAM Disable)
You can disable the D BEAM controller for the entire device.
OFF The D BEAM is enabled.
ON The D BEAM is disabled.
* Pressing the D BEAM [PITCH], [FILTER],
or [ASSIGNABLE] button to switch the D
BEAM controller on will have no effect.
Parameter/
Range
Explanation
PATCH EXTENT
You can set upper and lower limits to define the range of patches that
can be switched.
FROM Set the lower limits to define the range of
patches.
TO Set the upper limits to define the range of
patches.
Parameter/
Range
Explanation
FACTORY RESET
This restores the VB-99 to the settings it had when it was shipped
from the factory.
ALL All data.
SYSTEM Content of the settings for the SYSTEM
parameters.
GK SETTING Content of the settings for GK SETTING.
GLOBAL GLOBAL function settings.
PATCH Settings for patch numbers 001–200.
FAVORITE SETTING Content of the settings in FAVORITE
SETTINGS 01–10 for all effects.
VB-99_e.book 156 ページ ２００８年８月１８日 月曜日 午後１時１０分