Roland V-Bass VB-99 - Manual (Page 13)

13
Names of Things and What They Do
15. BALANCE Knob
Sets the mix balance. (p. 32)
16. CHAIN Button
Used to make settings for the effect and COSM bass/COSM
amp connection sequence. (p. 31)
17. CONTROL ASSIGN Button
This sets the functions assigned to pedals and switches. (p. 76)
18. NAME/KEY/BPM Button
Used to specify patch names (p. 34) and the tempo and key (p.
29) for songs to be played.
19. V-BASS LEVEL Knob
Adjusts the volume of a patch. (p. 33)
20. V-LINK Button
This switches the V-LINK function on and off. (p. 90)
21. DIRECT PATCH Buttons
Use these to directly call up the patches you have assigned to
them. (p. 81)
22. CONTROL Buttons
You can assign and control a variety of different functions
with these buttons. (p. 77)
23. EXIT Button
Used to return previous screens and to undo operations.
24. WRITE Button
Use for storing settings in patches and executing operations.
(p. 34) (p. 82)
25. PAGE Buttons
This switches the screens displayed in the LCD.
26. BASS TO MIDI Button
This sets the BASS TO MIDI function (the function that
converts what is played on the bass into MIDI signals). (p. 58)
27. SYSTEM Button
Used for making settings related to the VB-99’s operating
environment. (p. 35)
28. GLOBAL Button
This sets the GLOBAL function (which affects the tone of all
patches). (p. 40)
29. TUNER Button
This turns the tuning function on. (p. 23)
30. RIBBON CONTROLLER
This allows you to change the tone by sliding your finger
along the ribbon.
You can switch a variety of effects on and off directly with the
three buttons. (p. 73)
• PITCH Button
Changes the bass’s pitch. (p. 74)
• FILTER Button
Alters the brightness of the sound. (p. 75)
• ASSIGNABLE Button
Use this to assign different parameters and functions to
the ribbon controller and change the tone in real time. (p.
77)
31. GK IN Connector
Connect the GK cable here.
32. POWER Switch
Switches the power on and off. (p. 19) (p. 25)
33. OUTPUT LEVEL Knob
This adjusts the volume level for the MAIN OUT jacks and
headphone jack.
When a button is lit, it indicates that the function for
that button is switched on.
* The corresponding DIRECT PATCH button (1–5) lights when
a Direct Patch (1–5) is selected.
About the Illumination of Buttons
VB-99_e.book 13 ページ ２００８年８月１８日 月曜日 午後１時１０分