Roland V-Bass VB-99 - Manual (Page 20)

20
Chapter 1 Outputting Sounds
The VB-99 has a variety of Play screen variations, each providing
different information about the current state of the VB-99.
You can switch the information shown in the Play screen by pressing
PAGE [ ] [ ].
Screen 1:
The first nine characters of the patch name are displayed in large
type; also shown are icons for the basses and amps in both channels.
fig.01-060d
Screen 2:
All sixteen characters of the patch name are displayed.
Screen 3:
The effects used, as well as their connection sequence (CHAIN) in
both channels are indicated.
Screen 4:
The screen shows level meters for the GK IN strings Hi C–Low B,
normal pickup, MAIN OUT, and SUB OUT levels.
By assigning parameters to the F1–F6 knobs, as
described in
“Changing the Sounds with the Function
Knobs as You Play (DIRECT EDIT)” (p. 76), you can
use them to control values while in the Play screen.
Additionally, you can display a popup for the assigned
parameters and their values by pressing the [F1]–[F6]
buttons.
Some screens may contain parameters spanning multiple pages. The
page number is indicated at the upper right of the screen.
1. Use PAGE [ ] [ ] to switch pages.
2. Use [F1]–[F6] or the F1–F6 knobs to change
the values.
Pressing a FUNCTION button while SET** appears in
the lower part of the screen sets the corresponding
function to the indicated value of **.
Turn the OUTPUT LEVEL knob to set the volume to a suitable level.
fig.01-070
* The output level from the SUB OUT connector (XLR type) cannot
be adjusted with the OUTPUT LEVEL knob.
* You can adjust the volume level by assigning this function to the
expression pedal or GK-3B GK volume control. For details, see
“Using the Switches, Pedals, and MIDI to Control the
Sounds (CONTROL ASSIGN)” (p. 77).
About the Play Screen About the Information in the
Display (Basic Operation)
Adjusting the Volume
VB-99_e.book 20 ページ ２００８年８月１８日 月曜日 午後１時１０分