Roland V-Bass VB-99 - Manual (Page 16)

16
Chapter 1 Outputting Sounds
First install the GK-3B divided pickup (optional) on the bass to be
used. For installation instructions, refer to the GK-3B Owner’s
Manual.
The GK-3B cannot be used with the following basses (the
pickup will not function properly even when installed).
• Basses with an unconventional string configuration, such as
multi-stringed basses with seven or more strings, or double
basses (acoustic string basses)
• Nylon-stringed or gut-stringed basses and basses using any
non-steel strings
• Other basses whose construction does not provide adequate
space to properly attach the GK-3B
About the GK-3B’s GK Volume Control
With the VB-99, you can assign various different functions to the
GK-3B’s GK volume control. (p. 77)
You may not be able to control the VB-99’s volume level with the GK
volume control when another parameter is assigned to the GK
volume control.
About the GK-3B’s Select Switches
As the VB-99 allows you to set the balance between the COSM bass
and the normal bass volume in each individual patch, we
recommend that MIX be the basic function used for the select switch.
Also note that if a parameter other than volume is assigned as the
GK volume control function, the GK-3B’s select switch will stop
functioning normally.
To perform with the VB-99, first set up the following devices.
• A bass on which the GK-3B has been installed or equipped with
internal GK function
• Bass amp/speaker or headphones
Performing can be made even more convenient using the following
devices:
• MIDI foot controller (Roland FC-300; optional)
• Expression pedal (Roland EV-5 or BOSS FV-500L/500H with a
connection cable (stereo 1/4” phone – stereo 1/4” phone);
optional)
• Pedal switch (BOSS FS-5U or FS-6; optional)
Installing the Divided Pickup Before Connecting
VB-99_e.book 16 ページ ２００８年８月１８日 月曜日 午後１時１０分