Roland V-Bass VB-99 - Manual (Page 45)

45
Chapter 3 Global Device Settings (SYSTEM)
Chapter 3
This sets the signals and levels output for each of the VB-99’s output
jacks and connectors (MAIN OUT, SUB OUT, and DIGITAL OUT).
1. Press [SYSTEM].
2. Press PAGE [ ] [ ] to display Page 2.
3. Press [F1] (OUTPUT).
4. Set the OUTPUT MODE parameter to SYSTEM
with [F1] (SELECT) or with the F1 knob.
* If set to PATCH, the values set under “Setting the Output Signal
and Level (OUTPUT)” (p. 33) are enabled. The value in the
MIXER screen is disregarded, and instead the value < > is applied.
5. Set the signal and level output to each output
with PAGE [
] [ ] or with the F1–F6 knobs.
For detailed information on the parameters that can be
set, refer to
“OUTPUT” (p. 151).
Setting the Output Signal
and Level (SYSTEM OUTPUT)
VB-99_e.book 45 ページ ２００８年８月１８日 月曜日 午後１時１０分