Adjusting the sensitivity for each string (sens) – Roland V-Bass VB-99 User Manual

Page 38

Advertising
background image

38

Chapter 3 Global Device Settings (SYSTEM)

Set the clearance from the divided pickup to the bridge’s saddle for
each string.

*

This setting is not required when the GK PU TYPE is set to piezo-

type parameter.

1.

Follow Steps 1–5 in “Selecting the Settings”
(p. 35) to select the GK SETTING.

2.

Press PAGE [

] [

] to display Page 4.

3.

Rotate the F1–F6 knobs to set the clearance
for strings Hi C–Low B.

Adjust the divided pickup sensitivity for each string.

1.

Follow Steps 1–5 in “Selecting the Settings”
(p. 35) to select the GK SETTING.

2.

Press PAGE [

] to display Page 5.

3.

Rotate the F1–F6 knobs to adjust the
sensitivity.

Play each open string with the maximum force you’d use in an
actual performance, and set the sensitivity such that the meter
registers a level just before reaching the maximum level.

*

If the large segments at the right end of the level meter appear, it

means the level is set too high. Lower the sensitivity setting.

*

Pressing [F1]–[F6] initializes each string’s value to 65.

*

Depending on the bass you use, the level meter may move to the

maximum level even when the sensitivity is set to the minimum

setting. If this occurs, adjust the clearance separating the divided

pickup and the strings so the distance is slightly greater than

specified.

4.

Play the Low B through Hi C strings with the
normal amount of force; if any string sounds
particularly loud, lower the sensitivity setting
for that string, and keep adjusting until the
differences in the strings’ volume levels are
minimal.

Setting the Gap Between the
Pickup and the Bridge
(PICKUP

BRIDGE)

Settings

Explanation

0.0–50.0 mm

Specify the distance between the divid-
ed pickup and the center of each bridge
saddle.
The setting is disregarded when the GK
PU TYPE is set to piezo type parameter.

Bridge

Pickup

String

string 1

string Hi C

string Low B

string 2
string 3
string 4

Adjusting the Sensitivity for Each
String (SENS)

Settings

Explanation

0–100

Adjusts the divided pickup input sen-
sitivity for each string.

VB-99_e.book 38 ページ 2008年8月18日 月曜日 午後1時10分

Advertising
This manual is related to the following products: