Roland V-Bass VB-99 - Manual (Page 48)

48
Chapter 4 Using the VB-99 in Combination with an FC-300
This switches the FC-300’s AMP CTL 1 and AMP CTL 2 parameters
on and off.
When the bass amp’s channel switch jack is connected to the FC-
300’s AMP CONTROL 1 jack (or AMP CONTROL 2 jack), you can
then switch the bass amp channels with the VB-99’s AMP CTL1 (or
AMP CTL2) parameter.
1. Use the PATCH/VALUE dial to select the patch
you want to set.
2. Press [NAME/KEY/BPM].
3. Press [F4] (AMP CTL).
4. Use [F1] and [F2] or the F1 and F2 knobs to set
AMP CTL1 and AMP CTL2 to ON or OFF.
With Amp Control, not only can you switch amp
channels, you can also use it to switch the amp’s effects
on and off, like a foot switch controller.
Setting the FC-300 Amp
Control
Available Settings Description
OFF
The FC-300’s AMP CTL1 and AMP CTL2
parameters are set to OFF.
ON
The FC-300’s AMP CTL1 and AMP CTL2
parameters are set to ON.
VB-99_e.book 48 ページ ２００８年８月１８日 月曜日 午後１時１０分