RIDGID TS3650 - Manual (Page 15)

15
Unpacking and Checking Contents
Tools Needed
Unpacking
The TS3650 comes with two cartons
labeld 1 of 2 and 2 of 2. Make sure you
have both cartons before beginning
assembly.
1. Separate saw and all parts from
packing materials and check each
one with the illustration and the “List
of Loose Parts” to make certain all
items are accounted for, before
discarding any packing material. Call
1-866-539-1710 or E-mail us at
[email protected] if any
parts are damaged or missing.
WARNING: If any parts are missing,
do not attempt to assemble the
table saw, plug in the power cord or
turn the switch on until the missing
parts are obtained and are installed
correctly.
WARNING: To reduce the risk of
fire or health hazard, never use
gasoline, naphtha, or similar
highly volatile solvents.
WARNING: The saw is heavy. To
reduce the risk of back injury, get
help to lift the saw. Hold the saw
close to your body. Bend your
knees so you can lift with your
legs, not your back.
WARNING: For your own safety,
never connect plug to power
source outlet until all assembly
steps are complete, and you have
read and understand the safety
and operating instructions.
2. Remove the protective oil that is
applied to the table top and edges
of the table and table extensions.
Use any ordinary household type
grease and spot remover.
NOTE: Before beginning assembly:
• Check that all parts are included. If
you are missing any part, do not
assemble the saw.
• Sometimes small parts can get lost
in packaging material. Do not throw
away any packaging until saw is
put together. Check packaging for
missing parts before contacting
RIDGID.
• A complete parts list (Repair Parts)
is at the end of the manual. Use
this list to identify the part number
of the missing part.
3. Apply coat of paste wax to the table
and table extensions.
10mm, 11mm, 12mm, 14mm,
17mm, 1/2 in., 11/16 in.
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 15