RIDGID TS3650 - Manual (Page 41)

41
Mounting Switch on Right Side
1. Slide the nuts into the lower slot of the
front guide bar from the right end, with
the switch facing front.
2. Slide switch assembly left until the left
side of switch assembly is in line with
right side of main saw table - tighten
screws.
Mounting Switch on Left Side
1. Slide the nuts into the lower slot of the
front guide bar from the left end,
running wire behind unit, with switch
facing front.
2. Slide the assembly right until the right
side of the switch assembly is in line
with the left side of the main saw
table - tighten screws.
Securing Electrical Cords
Locate the following:
3 Wire Ties
Switch Mounted on Right Side
Route motor cord and power cord along
right side of cabinet. Use a hammer to
lightly tap the pointed tabs on the wire
ties into the two holes provided on the
right side of cabinet. Secure both cords
in wire ties.Loop motor cord in rear wire
tie to remove excess slack.
NOTE: One wire tie is extra.
Switch Mounted on Left Side
Route motor cord and power cord along
left side of cabinet. Use a hammer to
lightly tap the pointed tabs on the wire
ties into the three holes provided on the
left side of the cabinet. Secure both
cords through wire ties.
Installing Guide Bar End Caps
1. The left and right end caps for front
guide bar can be installed at this
time. Align the plastic end cap to
match profile of bar.
2. Install self tapping M4 pan head
screw into each hole.
3. The left and right end caps for rear
guide bar can be installed at this
time.
4. Install rear end caps as shown.
NOTE: This completes the assembly
of your table saw. Do not throw away
any remaining hardware until you
have read the entire operator’s
manual.
Front
End
Cap
Rear End
Cap
M4 x 1.6 x 12
Pan Head
Screws
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 41