RIDGID TS3650 - Manual (Page 20)

Assembly (continued)
1. Place the saw upside down onto a
smooth piece of cardboard or
heavy paper, on the floor, so the
saw is resting on the table top.
2. Place legs on saw so that holes in
saw base and leg set line up and
trim label is facing front.
3. Install screws and serrated flange
hex nuts as shown.
4. Tighten all leg assembly and
mounting hardware at this time.
20
WARNING: The saw is heavy. To
reduce the risk of back injury,
get help to lift the saw. Hold the
saw close to your body. Bend
your knees so you can lift with
your legs, not your back.
Screw
Serrated
Flange
Hex Nut
Leg
Base
Typical On
Each Leg
Mounting Your Saw
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 20