RIDGID TS3650 - Manual (Page 19)

19
4. Assemble the legs as shown.
Insert the screws through the holes
in the legs, then through the holes
in the end panels. Attach miter
gauge and rip fence storage hooks
as shown.
Legs must be assembled on top of
panels.
5. Screw on the serrated flange hex
nuts hand tight.
6. Insert the screws through the holes
in the legs, then through the holes
in the leg braces.
7. Screw on the serrated flange hex
nuts but do not tighten until
completely assembled.
8. Install leveling feet through holes in
foot stiffeners and bottom of legs as
shown. Adjust feet all the way up to
bottom of leg.
9. Once you have completed the
entire assembly process, move
saw to desired location and adjust
Miter Gauge
Storage Hook Rip Fence
Storage Hook
End
Panel
Leg
Brace
Screw Head
3/8-16
Hex Nuts
Leveling Foot
Herc-U-Lift
Systems Will
Be Installed Here
Foot
Stiffener
the four leveling feet to support the
tool as follows:
a. With 9/16" wrench loosen bottom
nut.
b. Back off top nut by hand.
c. Raise or lower foot by adjusting
bottom nut using 9/16" wrench.
d. Snug top nut against inside of leg
by hand.
e. Tighten all four bottom nuts using
9/16" wrench.
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 19