RIDGID TS3650 - Manual (Page 36)

Assembly (continued)
36
Adjusting Fence Indicator
The rip fence has two indicators. One to
use when the fence is on the right side of
the blade and one to use when the fence
is on the left side of the blade.
1. Place rip fence on saw table so that it
lightly touches the right side of the
blade and lock it in this position.
2. Loosen pan head screw. Adjust the
right indicator so that the red line is
located over the “zero” line of the right
rip scale and tighten screw.
3. Reposition rip fence on saw table so
that it lightly touches the left side of
the blade and lock it in place.
NOTE: If blade guard is already
installed, it must be temporarily removed
to perform this adjustment. Reinstall
when adjustment is complete.
4. Loosen pan head screw. Adjust the
left indicator so that the red line is
located over the “zero” line of the left
rip scale and tighten screw.
Installing Blade Guard
1. Locate the following parts:
2 Hex Head Screws,
1/4-20 x 5/8" Long
2 Serrated Flange Hex Nuts,
1/4-20
1 Thumb Screw
1 Spreader Support
Locate the following:
1 Blade Guard
2. Slide spreader support onto
spreader rod until notches engage
pin. Thread thumbscrew into
tapped hole and hand tighten.
3. Attach spreader to spreader
support so that the edge of the
spreader is even with the edge of
the spreader support as shown.
Tighten screws with a 7/16 wrench.
4. Raise blade all the way up, make
sure it is square with table.
5. Loosen both hex head screws
holding blade guard support to
cradle.
1/4-20 Serrated
Flange Hex Nut
1/4-20 x 5/8 In.
Hex Hd. Screw
Spreader
Support
Blade Guard
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 36