RIDGID TS3650 - Manual (Page 22)

Assembly (continued)
WARNING: Table extensions
must be installed. Front edge of
table and extensions must be
lined up. An uneven front edge
can twist the fence guide bar.
Twisted guide bars can misalign
fence. A misaligned fence can
cause binding or kickback. You
could be hit or cut.
WARNING: To reduce the risk of
injury from accidental start,
make sure switch is “OFF” and
plug is not connected to power
source outlet.
CAUTION: Insert must be even
with the table surface. Inserts
too high or low can let the
workpiece “snag” or catch on
uneven edges. Workpiece could
twist and kickback.
22
6. Tighten a “C” clamp over the edge of
table and extension at the center until
the extension is even with the table
surface as shown. Tighten the two
center nuts with a 1/2" wrench.
Checking Table Insert
1. Insert should be flush with table
top. Check as shown. Loosen flat
head screw that holds insert and
adjust the four set screws as
necessary. Tighten flat head screw.
Do not tighten screw to the point
where it bends the insert.
2. To remove insert.
a. Make sure saw is off and
unplugged.
b. Loosen flat head screw.
c. Lift insert from front end, and pull
toward front of saw.
d. To replace insert.
e. Make sure saw is off and
unplugged.
f. Place insert into insert opening in
table and push toward rear of saw
to engage spring clip and until
keyslot in insert will drop over flat
head screw. Tighten screw.
g. Do not tighten screw to the point
where it bends the insert.
"C" Clamp
Table Insert
3/32" Hex
"L" Wrench
Set
Screws
7. Repeat steps 5 and 6 to align the
other extension.
Flat Head
Screw
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 22