RIDGID TS3650 - Manual (Page 40)

Motor
Stud Flat Washer
Serrated Flange
Hex Nut
Belt
Guard
40
Assembly (continued)
2. Lower blade all the way down and
remove the motor belt.
3. Install one flat washer onto each of
the four motor studs.
4. Open the hinged belt guard by
pressing down on the tab lock as
shown.
5. Position the guard so the large hole
fits around the pulley. Insert the
motor studs through the four small
holes as shown.
6. Attach a serrated flange hex nut to
each motor stud as shown and
tighten securely.
7. Reposition the belt on the motor and
arbor pulley.
8. Close the hinged cover securely until
the tab snaps and locks the cover
closed.
9. Check the belt clearances on the
guard by raising the blade to full height
using the elevation handwheel.
10. Check motor clearances by rotating
the bevel handwheel located on the
right side until the indicator is set at 45°.
Mounting Switch and End Caps
Locate the following hardware:
2 Pan Head Screws With
Lockwasher, 10-32 x 3/8" Long
2 Square Nuts, 10-32
6 Pan Head Screws,
M4 x 1.6 x 12
Locate the following:
4 Plastic End Caps
1 Key Switch
2. Insert the 2 10-32 x 3/8" pan head
screws with lockwashers through the
outermost holes in switch assembly.
3. Install the 2 square nuts on the
screws so that there is an 1/8"+
clearance between the inside of the
nut and the top of the switch
assembly bracket.
NOTE: Switch assembly may be
mounted on left or right hand side of
saw.
Pan Head Screw
M4 x 1.6 x 12
10-32
Square Nut
10-32 x 3/8"
Pan Head
Screw
With
Lockwasher
Key Switch
10-32 x 3/8
Pan Head
Screw With
Lockwasher
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 40