RIDGID TS3650 - Manual (Page 18)

Assembly (continued)
18
Installing Elevation Handwheel
1. Locate the following hardware:
1 Handwheel
1 Elevation Lock Knob
1 Elevation Lock Tube
2. Slide elevation lock tube onto
elevation shaft.
3. Line up flat spots on shaft and
handwheel, push handwheel onto
shaft.
4. Screw elevation lock knob onto
shaft. Do not tighten at this time.
Handwheel Elevation
Lock Tube
Elevation
Lock Knob
Elevation Handwheel
Elevation Lock Knob
Elevation
Lock Tube
Assembling Leg Stand
1. Locate the leg stand.
Remove all parts from packing
material.
2. Locate the following hardware:
23 Truss Head Screws,
5/16-18 x 5/8” long
23 Serrated Flange Hex Nuts,
5/16-18
4 Leveling Feet
8 3/8-16 Hex Nut
3. Locate the following:
4 Legs
2 End Panels
2 Leg Braces
1 Miter Gauge Storage Hook
2 Rip Fence Storage Hooks
4 Foot Stiffeners
Rip Fence
Storage Hooks
5/16-18 x 1/2 In.
Head Screw
3/8-16
Hex Nut
Leveling
Foot
Leg
Braces
End Panel Miter Gauge
Storage Hook
Leg
Foot
Stiffener
Rip Fence
Storage
Hook
5/16-18 Serrated
Flange Hex Nut
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 18