RIDGID TS3650 - Manual (Page 34)

Assembly (continued)
34
Installing Spacer Bar
1. Locate the following hardware:
2 Set Screws 10-32 x 7/16" long
From unlabeled bag assembly
remove the following:
2 Locking Plates
From among the loose parts find the
following:
1 Spacer Bar
2. To determine how many shim
washers (shown on previous page)
will be needed, slide the reduced
ends of the spacer bar into the "T'
slots of the front and rear guide
bars. Push the spacer bar against
the fence brackets and toward the
front of saw. If there is a gap
between the large diameter of the
spacer bar and the inside of the
rear guide bar, fill the gap with the
appropriate number of shim
washers. Remove the spacer bar
and place the shim washers over
the reduced end of the bar.
3. Thread one of the set screws into
each of the locking plates as
shown.
4. Place one locking plate assembly
over each end of the spacer bar
with the bent legs pointing out as
shown.
5. Slide the locking plates, set screw
end first, into the “T” slots in the
front and rear guide bars. Locate
the spacer bar approximately
4-1/2" in from the end of the rear
guide bar and parallel to the side of
the table.
6. Use a 3/32" hex wrench to tighten
both set screws while holding the
bar in place.
Approximately 4-1/2"
3/32" Hex Wrench
Spacer
Bar
Parallel
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 34