RIDGID TS3650 - Manual (Page 28)

Assembly (continued)
28
Lower Assembly
1. Locate the following hardware.
4 Hex Head Screw w/Washer
1/4-20 x 2
4 Lock Nut 1/4-20
4 Hex Nut w/Serrated Flange
5/16-18
2 Hex Nut w/Serrated Flange 7/16
1 U-Bolt
2. From the loose parts find the
following:
2 Caster
2 Tube Front (13-7/8" Long)
1 Tube Support (17-1/4" Long)
1 Tube U-Bolt (19-5/8" Long)
3. Assemble support tube (17-3/4 inch
length) to both front tubes (13-7/8
inch length) using two each 1/4-20 x 2
hex head screw, and lock nut as
shown. Loosely assemble at this
time.
NOTE: The larger hole at the end of the
front tube must face down as shown.
4. Align and assemble U-bolt tube
(19-5/8 inch length) with holes in the
front tube using two each 1/4-20 x 2
hex head screw, and lock nut as
shown. Loosely assemble at this time.
5. Assemble 5/16 nut on each side of
U-bolt as shown with serration facing
tubing.
6. Place U-bolt through holes in U-bolt
tube. Assemble 5/16 nuts on each
side of U-bolt as shown with serration
facing tube.
7. Adjust U-bolt about two inches from
tube.
8. Assemble caster through tube. Fasten
with 7/16 nut as shown. Tighten nuts
securely. Use adjustable wrench on
caster stem hex to keep stem from
turning while tightening nut.
Assemble each tube exactly as
shown. Note both front tubes are
placed on top of the tube U-bolt
and tube support as shown.
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 28