RIDGID TS3650 - Manual (Page 29)

29
Installation Instructions
1. Locate the following hardware:
4 Hex Head Screw w/Washer
1/4-20 x 1-5/8
4 Washer 1/4 I.D.
12 Lock Nut 1/4-20
8 Hex Head Screw 1/4-20 x 1/2
2. Locate the following:
4 Bracket
3. Install the four leg brackets on the
inside of each leg using 1/4-20 x
1/2" hex head screws and lock
nuts. Tighten screws securely.
4. Place the Lower Assembly under
the saw with the front ends of the
tube under the front leg brackets.
Install the hex head screw (1/4-20 x
1-5/8) through the front leg bracket
and tube as shown. Install the
washer and lock nut until lock
nut is flush with end of screw.
The screw should freely pivot side
to side.
5. Place the upper assembly under
the saw (see illustration) with the
rear ends of the tube under the leg
brackets and install the hex head
screw (1/4-20 x 1-5/8), washer and
nut in the same manner as step 4.
Center the upper tubes between
the lower tubes and tighten all
hardware at this time beginning
with the four (4) screws attaching
the plate assembly to the tubes.
Assembling Herc-U-Lift™ Caster System to Saw
WARNING: To reduce the risk of
injury from unexpected starting,
unplug the tool before attaching
caster set.
6. Insure the upper tubes remain
centered between the lower tubes
and tighten the hardware on the
lower assembly.
7. Press down on the plate assembly
and check alignment of the U-bolt.
The U-bolt should be centered
within the latch mechanism as
shown. Release pedal and adjust
the U-bolt as necessary, then
tighten the nuts holding the U-bolt
to the tube.
Leg Bracket
Center Frames Equal
Distance on Each Side
Tighten All Nuts
RIDGID
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 29