Rockwell SoniCrafter DEVICENET 1771-SDN - Manual (Page 44)

Publication 1771-6.5.132 - June 2000
3-6 Hardware Setup
3. Insert the interface module/processor combination in the left-most
slot of the 1771 I/O chassis.
4. Assign an IP address to the interface module.
5. Configure channel 3A for Ethernet communication.
You can configure the communication channel using BOOTP
software or your PLC-5 programming software. See Appendix A for
information on configuring the communication channel using
RSLogix 5 programming software.
For more information, see the PLC-5 Ethernet Interface Module User
Manual, publication 1785-6.5.19.
Be sure power to the
1771 I/O chassis is OFF.
!
TIP
Rockwell Automation offers a BOOTP tool on
http://www.ab.com
More