Rockwell SoniCrafter DEVICENET 1771-SDN - Manual (Page 95)

1 Publication 1771-6.5.132 - June 2000
Chapter
6
Creating and Running the Example
Application Program
What This Chapter Contains This chapter describes the procedure to create, download, and run an
example ladder logic program to test the DeviceNet network. When
the program is put into Run mode, pressing the START button on the
network’s RediSTATION will cause the red indicator light to come on
and stay on until the STOP button is pressed. Passing an object in
front of the photoeye will increment a counter.
This chapter provides examples of downloading and running the
program over ControlNet, Ethernet, and Data Highway Plus networks.
You cannot directly communicate with the PLC-5 processor over the
DeviceNet network.
The 1771 I/O chassis used for these examples was set up with the
following hardware:
The following table describes what this chapter contains and where to
find specific information.
For more information, see Getting Results With RSLogix 5, Rockwell
Software publication 9399-RL53GR.
Module Rack Group Slot IP Address
PLC-5/1785-ENET 0 0 0 130.130.130.2
1771-SDN 0 1 0 n/a
For information about See page
Installing the Software 6-2
Creating the Example Application Program 6-2
Downloading and Running the Program 6-6
Downloading and Running the Program via a ControlNet Network 6-6
Downloading and Running the Program via an Ethernet Network 6-9
Downloading and Running the Program via a DH+ Network 6-12
More