Rockwell SoniCrafter DEVICENET 1771-SDN - Manual (Page 51)

Publication 1771-6.5.132 - June 2000
Hardware Setup 3-13
How Your Example
System Will Look When you have finished installing all the devices, your example
system should look similar to the one shown below:
What’s Next? The next step is to configure the 1771-SDN module and perform I/O
data mapping using RSNetWorx for DeviceNet software.
Series 9000
Photoelectric
Sensor
RediSTATION
Operator Interface
PLC-5 Processor with 1771-SDN
module in 1771 I/O chassis
Node 7
Node 9
Node 62
1770-KFD
Communication
Module
Node 0
24V
PC Serial
Port
1492-DN3TW
Quad Tap
PC running Windows NT
or Windows 95/98,
containing RSNetWorx for
DeviceNet software
IMPORTANT
Make sure each end of your DeviceNet trunk cable
is properly terminated with a resistor. Refer to the
DeviceNet Cable Planning and Installation Manual,
publication DN-6.7.2 for detailed information.