Roland XP-30 - Manual (Page 105)

105
Chapter 3. Creating Your Own Sounds
Chapter 3
30: DISTORTION → FLANGER
This effect connects distortion and flanger in series. The
parameters are essentially the same as in “27:
OVERDRIVE
→ FLANGER,” with the exception of the
following two.
OD Drive
→ Dist Drive (Specify the amount of distortion.)
OD Pan → Dist Pan (Specify the stereo location of the
distortion sound.)
fig.3-75
31: DISTORTION → DELAY
This effect connects distortion and delay in series. The
parameters are essentially the same as in “28:
OVERDRIVE
→ DELAY,” with the exception of the following
two.
OD Drive
→ Dist Drive (Specify the amount of distortion.)
OD Pan → Dist Pan (Specify the stereo location of the
distortion sound.)
fig.3-76
32: ENHANCER → CHORUS
This effect connects an enhancer and a chorus in series.
fig.3-77
Enhancer Sens #
Adjust the sensitivity of the enhancer.
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Cho Dly (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
ChoRate (Chorus Rate)
Adjust the modulation speed of the chorus effect.
Chorus Depth
Adjust the modulation depth of the chorus effect.
Chorus Balance #
Adjust the volume balance between the enhancer sound that
is sent through the chorus and the enhancer sound that is not
sent through the chorus. With a setting of “D100: 0W,” only
the enhancer sound will be output. With a setting of “D0:
100W,” only the enhancer sound that is sent through the
chorus will be output.
Level (Output Level)
Adjust the output level.
33: ENHANCER → FLANGER
This effect connects an enhancer and a flanger in series.
fig.3-78
Enhancer Sens #
Adjust the sensitivity of the enhancer.
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Flg Dly (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
FlgRate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Flg Dpt (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Flg Fbk (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Flanger Balance #
Adjust the volume balance between the enhancer sound that
is sent through the flanger and the enhancer sound that is not
sent through the flanger. With a setting of “D100: 0W,” only
the enhancer sound will be output. With a setting of “D0:
100W,” only the enhancer sound that is sent through the
flanger will be output.
Level (Output Level)
Adjust the output level.
L in
R in
Flanger Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
L in
R in
Delay Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Chorus
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D
Feedback
Flanger
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D