Roland XP-30 - Manual (Page 146)

146
Quick Reference of Procedures
Turning Off Transmission of Program
Change/Bank Select MIDI Messages
(System)
TRANSMIT MIDI display (SYSTEM/MIDI)
Transmitting Bank Select Messages for
the Patch Assigned to a Specific Part
when a Performance is Selected
1. Set the Bank Select Group parameter (PERFORM/MIDI/
TRANSMIT) to the desired Bank Select Group number
(BS1–BS7).
2. Save the Performance.
3. In the BANK SEL-GROUP display (SYSTEM/MIDI/
BANK SEL-GROUP), select the Bank Select Group that
you specified in step 1.
4. Turn the Switch parameter ON, and specify the MSB and
LSB.
■ Controlling the XP-30 from an
External MIDI Device
Changing the Receive Channel on
which Performances will be Selected
Control Channel parameter (SYSTEM/MIDI/PERFORM
MIDI)
Changing the Receive Channel of a
Part (Performance)
Channel parameter (PERFORM/MIDI/MIDI)
Changing the Receive Channel (Patch)
Rx-Ch parameter (SYSTEM/MIDI/PATCH MIDI)
Turning Off Reception of Program
Change/Bank Select MIDI Messages
(System)
RECEIVE MIDI display (SYSTEM/MIDI)
Turning Reception of Volume/Hold 1/
Program Change MIDI Messages ON/
OFF for Each Part (Performance)
Rx SWITCH display (PERFORM/MIDI)
Turning Reception of Volume/Pan/Pitch
Bend/Hold 1/Redamper MIDI Messages
ON/OFF for Each Tone (Patch)
Rx SWITCH/DAMPER display (PATCH/CONTROL)
Checking the MIDI Message Reception
Status (Performance mode)
INFO display (PERFORM/INFO)
■ Other
Using the Panic Function
Press [SHIFT] + [PANIC].
Adjusting the Tuning
Master parameter (SYSTEM/TUNE/TUNE)
Adjusting the Display Contrast
LCD Contrast parameter (SYSTEM/SETUP/SYSTEM
SETUP)
Restoring the Temporary
Performance/Patch/Rhythm Set to the
Factory Setting
1. Select a Performance, Patch, or Rhythm Set.
2. Press [UTIL/CARD].
3. Select “3: INIT” on the UTIL 1 display.
4. Select “PRESET”.
5. Press [ENTER].
Restoring the XP-30 to the Factory
Settings
1. Select a Performance, Patch, or Rhythm Set.
2. Press [UTIL/CARD].
3. Select “4: FACTORY RESET” on the UTIL 2 display.
4. Press [ENTER].