Roland XP-30 - Manual (Page 26)

26
Getting Ready
Turning On the Power
1
Before you turn the power on, check to make sure that:
• All external devices are correctly connected to the XP-30.
• The volume controls of the XP-30 and the amp/mixer system are turned
down all the way.
2
Turn on the power switch located on the rear panel of the XP-
30.
fig.Q-06
3
Turn the power on of your amp or audio system.
4
Play the XP-30 and gradually raise the volume controls of the
XP-30, your amp or mixer to an appropriate volume level.
fig.Q-07
■ Turning Off the Power
1
Before you turn power off, check to make sure that:
• The volume controls of the XP-30 and the amp/mixer system are turned
down all the way.
• Important data has been saved to a memory card (p. 122).
2
Turn off your amp/mixer system.
3
Turn off the XP-30 power.
Once the connections have
been completed (p. 24),
turn on power to your
various devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
Be careful not to raise the
VOLUME slider of the XP-
30 too much. Excessive
volume may damage your
amp/speaker system or
could cause hearing