Roland MMP-2 - Manual (Page 10)

10
Top and Rear Panels
These adjust the [MIC IN] sensitivity. (p. 17)
10. [PEAK] Indicators
These light up when the input level exceeds the set value. (p. 17)
11. [PHANTOM/PHASE/LO-CUT] Buttons
These call up the Phantom power switches, plus the Phase, Lo-cut, and Attenuator setting screens. (p. 17)
12. [EDIT CH SELECT] Buttons
These specify the channels to manipulate. Pressing them simultaneously links the effect settings for both
channels. (“Linking” (p. 28)).
13. [BYPASS] Buttons
These bypass effects temporarily. (p. 19)
14. [EDIT SELECT] Buttons ([MODEL] Button)
This calls up the editing screen for microphone modeling. (p. 19)
15. [EDIT SELECT] Buttons ([EQ] Button)
This calls up the parameter screen for the equalizer. (p. 20)
16. [EDIT SELECT] Buttons ([DYNAMICS] Button)
This calls up the parameter screen for dynamic effects. (p. 21)
17. [EDIT SELECT] Buttons ([PLUG IN] Button)
This calls up the editing screen for plug-in effects. (p. 24)
Rear Panel
1. [POWER] Switch
This switches the power on and off. (p. 13)
2. [AC IN] Connector
This is for connecting the power cable. (p. 12)
3. [DIGITAL OUT AES/EBU] Jack
This is an AES/EBU-standard digital-output jack.
4. [DIGITAL OUT] Jack
This is an S/PDIF-standard digital-output jack.
5. [DIGITAL IN] Jack
This is an S/PDIF-standard digital-input jack.
6. [USB] Jack
This is for connecting a computer and exchanging parameter settings using MIDI protocol. (p. 30)
7. [OUTPUT LEVEL] Switch
This switches the output level to either -16 dBu or +4 dBu. (p. 13)
8. [LINE OUT] Jack
This is a balanced XLR-type line-output jack. (p. 13)
1 2 3 4 6 7 8 5 1 2 3 4 6 7 8 5