Roland MMP-2 - Manual (Page 32)

32
Use of computer and setup
7. Use the USB cable to connect the MMP-2 to your computer.
As appropriate, switch the USB select switch to either the front or the rear position.
fig.02-01.e
8. Turn on the power of the MMP-2.
* After you have made connections correctly, you must turn on the power in this step. If you fail to observe the correct sequence,
the system may malfunction.
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all
devices before making any connections.
fig.01-01
9. In some cases, the “Insert Disk” dialog box may appear.
Click “OK.”
fig.10-01
10. The “New Hardware Found” dialog box will appear.
In the “Copy files from” area, input
“Q:\Driver\WinMe_98” and click the “OK” button.
Installation will be completed.
* Change the drive name Q: to match the drive name of your CD-
ROM drive. For example if your CD-ROM drive is named D:,
you would input “D:\Driver\WinMe_98”.
11. Click “OK” button in the “SETUPINF” dialog box.
This completes the installation of the MMP-2 driver
and the settings.
Read “ReadMe” of adopted CD-ROM in case you use MMP-2 Editor.
Windows 2000
Use the following procedure to install the MMP-2 driver.
* Disconnect the MMP-2 from your computer before starting up Windows.
* To install the driver, you must log on to Windows as the Administrator or other user with the privileges of the Administrators
group. For more information regarding this, consult your computer system administrator.
* The MMP-2 cannot be used with Windows95 or Windows NT.
USB cable
USB connector
MMP-2
'Roland MMP-2 USB Driver Installation Disk',
'Roland
MMP-2 Driver Installation Disk'
7
Q:\Driver\WinMe_98
Deleting the MMP-2 Driver
If you were not able to install the MMP-2 driver according to the procedure, or if you are unable to use the
MMP-2 even after installing the driver, you must delete the driver.
After deleting the driver, use the procedure described in “Windows Me / 98”(p. 31) to re-install the
driver.
For details on how to delete the driver, refer to the explanation provided in the on-line
manual(Readme_e.htm) within the MMP-2 Driver & Software CD-ROM.