Regency Bellavista Gas Fireplace B36X - Manual (Page 15)

Regency Bellavista™ B36X Gas Fireplace
15
INSTALLATION
TOP FLUE COLLAR INSTALLATION
Note: This conversion must be done prior to the unit being placed in position.
The unit comes equipped as a rear vent unit. These instructions are to be used, only if the unit is going to be top vented.
Top Collar Assembly Kit
1 Intake Collar Assembly with Gasket
1 Intake Collar Plate with Gasket
1 Top/Rear Exhaust Assembly with Gasket
1 Heat Defl ector
1 Baffl e Plate
29 1/4" x 1/2" Screws (4 spares)
1 Restrictor
1 Intake Collar Gasket (spare)
1 Exhaust Assembly Gasket (spare)
Exhaust Assembly
w/ gasket
Intake Collar Plate
w/gasket
Intake Collar Assembly
w/gasket
2) From inside the fi rebox, remove the top heat defl ector by removing
2 - 1/4" x 1/2" screws.
Heat Defl ector Diagram 2
1. Remove the door assembly by releasing the adjustable latches and lifting up off the door frame assembly.
Adjustable Tension
Latch location
Diagram 1
3) From inside the fi rebox, remove the baffl e plate by removing 4 - 1/4"
x 1/2 " screws. See Diagram 3
Baffl e Plate
Diagram 3
4) From the inside of the fi rebox, remove the exhaust assembly by
removing the 8 - 1/4" x 1/2" screws. See Diagram 4.
Diagram 4
UNIT ASSEMBLY PRIOR TO INSTALLATION